VTech VM3254 Camera Stand Replacement

Scritto Da: Christina Block
  • Commenti: 0
VTech VM3254 Camera Stand Replacement

Difficoltà

Moderate

Passi

2

Tempo Necessario

5 minuti

Introduzione

If the camera stand is cracked or it seems to be unbalanced, you may need to replace it with a new one. Below are the following steps to replace the camera stand in order for there to be balance and it to stand securely.

  1. 6LjWtG4FgtNPY3DD
    6LjWtG4FgtNPY3DD
    e16PhgDoacMIBXKD
    bNBYXPoc1HsLIjhd

    • Unscrew and remove the two 8 mm Phillips #0 screws from the bottom of the stand.

    • Use the Jimmy tool to open the stand.

    • You may need to use an opening pick to hold it open.

    • Remove the bottom of the stand.

  2. Zy4vjPuBEoGPjNmV

    • Replace with a new stand.

    • Use the solder to solder where the cords fit into place.

    • Careful with the solder to not break the motherboard or any other parts.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Christina Block

Membro da: 10/02/23

375 Reputazione

0 commenti