WRS315SDHW Defrost Heater Replacement

Scritto Da: nicO
  • Commenti: 0
WRS315SDHW Defrost Heater Replacement

Difficoltà

Moderate

Passi

12

Tempo Necessario

15 - 30 minuti

Introduzione

Use this guide to replace the defrost heater in your Whirlpool WRS315SDHW Refrigerator.

The defrost heater melts frost off the evaporator fins. If your freezer is perpetually frosty, then the defrost heater might be broken.

Note: Some photos show the doors removed for clarity purposes. Removing them is not required and will not change the procedure.

  1. GAB31IUS1UwNdE6E

    • Before you begin your repair, perform the following:

    • Turn off your main water supply

    • Unplug your device

  2. uZnovp3POltPPcNl
    uZnovp3POltPPcNl
    EEmEHtDyinkLLTC6
    NpS45AODrJVIyexU

    • Depending on your repair, open one or both doors.

  3. hkAwPUpRPNIPxRGV
    hkAwPUpRPNIPxRGV
    L4ikmh2NQXFogcpt

    • Remove the drawers and shelves from the freezer section.

  4. PYjtoq32XfA1ZLfx
    PYjtoq32XfA1ZLfx
    vH1YKrFTgcoJSpj3

    • Remove the screw(s) securing the evaporator cover.

  5. EHSDsDxpXbXtjjSW
    EHSDsDxpXbXtjjSW
    Wf2DVMGatSZhfSRa
    2oHDgU6UMdQXqWmO

    • Lift the bottom of the evaporator cover up and over its lip in the chassis.

    • Pull the cover toward yourself to release its top clips.

  6. YeaE3oqkUY5iSaJh
    YeaE3oqkUY5iSaJh
    TdRPKBwJHWNGAEoK
    41LUePiTbxqKJb1K

    • Continue pulling the evaporator cover towards yourself to unclip its metal prongs from the chassis.

    • Remove the evaporator cover.

  7. S6efuAniO34UP3eR
    S6efuAniO34UP3eR
    UQ2lM5wAMGCZATut
    CIPXBMcHUkPLL2qA

    • Disconnect the two spade connectors attached to the defrost heater.

  8. xKoauoH1GDKCVaua
    xKoauoH1GDKCVaua
    36FSgOcVx5XARLeX
    1IIXeqPf4dcZXrxd

    • Pull the defrost heater cable out from behind the evaporator.

  9. S6RrRldnDWPxs2Vy

    • Use a 1/4 inch socket wrench to remove the 16.5 mm-long screw securing the defrost heater bracket.

  10. ZFR2V3GtIJpgPnhB
    ZFR2V3GtIJpgPnhB
    DbPEb5aVCrDcZSIn

    • Pull the defrost heater bracket up to release it from its slot in the chassis.

  11. odT4M1guQMbUPJw2
    odT4M1guQMbUPJw2
    oUUbvoWvQFBrhN6X
    OWXPNfeyhZJ2yYEQ

    • Slide the defrost heater from under the evaporator.

    • You may need to pull one end at a time until it's completely removed.

  12. VSKrInsAKdmxdARv

    • You're now left with the defrost heater.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Ask our Answers community for help.

Autore

nicO

Membro da: 14/04/15

15885 Reputazione

0 commenti