Whirlpool WED87HED Control Panel Replacement prereq

Scritto Da: Bill Gilbert
  • Commenti: 0
Whirlpool WED87HED Control Panel Replacement prereq

Difficoltà

Moderate

Passi

4

Tempo Necessario

Nessuna stima

Introduzione

  1. 4EqwYWjHdXpSDP2P
    4EqwYWjHdXpSDP2P
    I5XdQIMZQChnl4Ap

    • Disconnect the control panel cable from the main board.

  2. O21IMM2KKfDgSXgW
    O21IMM2KKfDgSXgW
    2i3v6ir4JGoNnvAC

    • Disconnect the drum light connector.

  3. vgpvSUy3LVl3MKa2
    vgpvSUy3LVl3MKa2
    5KH3EZG4GCmRwFVH

    • Use a 1/4 inch nut driver to remove the two 16.3 mm‑long sheet metal screws located at each end of the control panel.

  4. oZUJsARu4qoKMFBq
    oZUJsARu4qoKMFBq
    OQBZEtdPmGqahirE
    kBuvEfxxfEZJiHPk

    • Lift the control panel up and tilt it away from the chassis to remove it.

    • Make sure to thread the cable through the hole in the chassis.

    • During reassembly, thread the cable through its proper hole before reinstalling the control panel.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Bill Gilbert

Membro da: 30/06/22

29837 Reputazione

0 commenti