Wyze WVCR200s Battery Replacement

Scritto Da: Brandon Amado
  • Commenti: 0
Wyze WVCR200s Battery Replacement

Difficoltà

Moderate

Passi

6

Tempo Necessario

10 - 20 minuti

Introduzione

If the battery of your Wyze WVCR200s robot vacuum isn't charging or won't hold a charge, you may need to replace the battery. This guide demonstrates how to replace the battery of your Wyze WVCR200s. Start off by checking the connection from the battery to the port. For your safety, make sure the device in fully powered down before attempting to remove the battery.

  1. FoyShLOZvyECYMf1

    • Flip the vacuum upside down so the bottom is facing up.

    • In the center of the device, you should see the rotating brush that stretches from one wheel to the other.

  2. THLxWTAH4CJEODpC
    THLxWTAH4CJEODpC
    qeL42iOBKDfaWhbH

    • Pinch the blue tabs below the rotating brush towards each other.

    • Lift the plastic housing surrounding the rotating brushing straight up, and the remove it from the vacuum.

  3. SwKLSahCwuqiTLub
    SwKLSahCwuqiTLub
    NxDcHTN3RmecsTeb
    LUdeQe16dmABWCIm

    • To remove the rotating brush, lift one end of the brush upwards, and remove.

  4. VTl3JVJQggGwrbjE

    • Use a screwdriver to remove four screws along the edge, just above where the brush was removed.

  5. INTMDoBETKT23MlO

    • Lift the battery cover up and out of the vacuum.

  6. opHIaBF5DeSuEtie
    opHIaBF5DeSuEtie
    j2LIJP2dOODOcBW6

    • Lift the battery out from underneath the cover.

    • Be careful not to pull or yank the battery out, it is connected by wires to the vacuum port.

    • Carefully disconnect the battery from the vacuum port.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Brandon Amado

Membro da: 20/03/23

411 Reputazione

0 commenti