Introduzione
If the controller stops vibrating, the rumble motors might be broken or disconnected. This guide will show you how to open the controller and replace the rumble motors.
-
-
Turn the controller on its backside and push the "eject" button to discharge the battery compartment door on the bottom of the controller.
-
Pull the two AA batteries out.
-
-
-
Remove the holographic Microsoft sticker with the percision tweezers to reveal a small screw.
-
Use a T6 Torx screwdriver to remove the 1.5mm screw.
-
-
-
Insert a spudger and pry at these three locations to detach the middle cover.
-
Pull off the middle piece cover to reveal three screws.
-
Use a T8 Torx screwdriver to remove the three 2.3mm screws.
-
Remove the cover.
-
-
-
Remove the two 90mm screws with a T8 Torx screwdriver.
-
Lift up the silver middle piece to remove.
-
-
-
Use a spudger to remove the silver prong.
-
With the spudger, pinch the metal spring and slowly pull up to remove.
-
Use the spudger to remove eject button.
-
Remove the screw holding in the eject button with a T8 Torx screwdriver.
-
-
-
Pull the two halves apart at the bottom to detach the two latches that are holding the front and back panels together.
-
Start with one side of the controller (left or right).
-
Slide the spudger towards the end of the handles and pry the two halves apart. Do the same for the opposite side.
-
Pull the front and back panels apart to separate them and expose the inside of the controller.
-
-
-
Lift the battery compartment out of the controller and set it outside of the controller.
-
Use the precision tweezers to pull out the red and black wire attached to the white plug at the bottom side of the circuit board.
-
-
-
Use precision tweezers to remove the red and black wires that are attached to the circuit board.
-
To reassemble your device, follow these instructions in reverse order.
