Introduzione
The buttons on the adapter are glued to a rubber mold within the adapter. It will take patience to scrape away this glue without damaging the rubber mold.
Strumenti
- 
                  
                  
- 
            
Insert the flat edge of a metal spudger in the seam between the adapter body and the plastic casing. Move the spudger into one of the corners.
 - 
            
Push down on the spudger to separate the casing from the adapter until you hear a click and the casing stays open on that side.
 - 
            
Do the same to the other side until the casing comes off.
 
 - 
            
 - 
                  
                  
- 
            
Remove three 5.0 mm T5 Security Torx screws along the edges of the controller housing.
 - 
            
Remove two 8.0 mm T5 Security Torx screws near the top-center of the adapter.
 
 - 
            
 - 
                  
                  
- 
            
Pull back on the controller USB connector with your finger to separate the main adapter circuit board from the rubber mold in the button panel.
 
 - 
            
 - 
                  
                  
- 
            
With your fingers, partially peel back the rubber molding near the button you want to replace.
 - 
            
Using the straight, pointed end of a small pointed spudger, scrape off the glue between the plastic button and the rubber mold.
 
 - 
            
 - 
                  
                  
- 
            
Grip the plastic tabs on either side of the button with tweezers.
 - 
            
Squeeze the tweezers to pop the button out the front face of the button panel.
 
 - 
            
 
To reassemble your device, follow these instructions in reverse order.