Xiaomi ROBOROCK S50200 laser unit repair

Scritto Da: hainzy
  • Commenti: 0
Xiaomi ROBOROCK S50200 laser unit repair

Difficoltà

Moderate

Passi

6

Tempo Necessario

5 minuti

Introduzione

In this guide, I will show you how to replace the laser unit or the LIDAR or its motor.


Replacing the entire unit or just the motor can be the solution if the Roborock S5 reports "Error 1".

  1. Tqwgh1STS11nBhEc
    Tqwgh1STS11nBhEc
    HaRNvcmjjhFGppEA

    • Turn off the device by pressing and holding the power button.

  2. gYIWOlPGDjxAjCS1

    • Open the cover upwards.

    • Lift the dustbin upward to remove it.

  3. UXePhO4mmoDEsBNM
    UXePhO4mmoDEsBNM
    N6UmsVlLpbIZshXC

    • Insert the spudger from the side

    • Release the clips by turning the spudger

    • Lift the cover upwards

    • These pictures show the front bumper already removed. This is not necessary for these instructions.

  4. oCVSHcLgOmkvjvuy
    oCVSHcLgOmkvjvuy
    rfYhawfhGAlsIwGs
    WBfAwWnL1SnZTlWD

    • Loosen the 6 screws for the hinges

    • Lift and remove the hinges

    • Remove the flap upwards

  5. EkUDtSSax6FUJNWp
    EkUDtSSax6FUJNWp
    UljvQqjf3THCwRrn
    QjBilZT5VMUasUsY

    • Remove the 5 screws for the cover

    • Remove the cover upwards

  6. 6mxmVorYuWM4rGT2
    6mxmVorYuWM4rGT2
    AmvKDGbw3nCFvWwf

    • Remove the 4 screws of the laser unit

    • Remove the unit upwards (unit is still plugged into the circuit board)

Conclusione

Work through the steps in reverse order to reassemble your device.

Autore

hainzy

Membro da: 23/03/23

5227 Reputazione

0 commenti