ZD-N Plus Wireless Controller Repair D-Pad Replacement

Scritto Da: Devin Matos
  • Commenti: 0
ZD-N Plus Wireless Controller Repair D-Pad Replacement

Difficoltà

Moderate

Passi

9

Tempo Necessario

15 minuti

Introduzione

This guide is designed to assist in the replacement of the D-Pad for the ZD-N Plus Wireless Controller. Directional pads can be purchased at local electronics stores.

  1. PcWemsiVJLRBByES

    • Remove the seven 12mm JIS #00 screws that hold the back panel in place.

  2. PIJjk6I6btCyYbcj
    PIJjk6I6btCyYbcj
    i6sCUV2BYE2sUUYE

    • Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.

  3. aDlpUFMODc2NGDy6

    • Use an opening tool to pry the battery from its original position.

    • The battery is glued on, so this may take some effort.

  4. NlCqEGTjVJJp5BPx
    NlCqEGTjVJJp5BPx
    sIFKKiBveCHMfnZV

    • Use an opening tool to pry the connector away from the two metallic prongs.

    • The parts are built to stay together, so this may take some effort.

    • Be careful to not warp the prongs in the process.

  5. tPydjZrm5bfx4agP
    tPydjZrm5bfx4agP
    5JJrTAoxUYXQXRib

    • Remove the battery from the controller.

  6. nJdXqTMAMASsvwn6
    nJdXqTMAMASsvwn6
    ihPemglJqy2wrYxQ

    • Remove the electrical connector attaching each rumble motor to the controller.

    • Lift up on the circular section of the rumble to remove it from the controller.

  7. QT4cUjIAcACTyYJV
    QT4cUjIAcACTyYJV
    JROV1DlME2DWYeQa

    • Remove the three 1.2mm JIS #00 screws that hold the motherboard in place.

  8. 5EuKG3OySRHkA2Gn

    • Lift the motherboard out of the controller.

  9. yAJpnLNVqyciAI5h
    yAJpnLNVqyciAI5h
    QcL41nPRgmZHynNR

    • Simply remove the plastic piece of the directional pad. It is not glued in so it should come out easily.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Devin Matos

Membro da: 15/10/19

181 Reputazione

0 commenti