Zeki TBQG884B Camera Replacement

Scritto Da: Natalie Holm
  • Commenti: 0
Zeki TBQG884B Camera Replacement

Difficoltà

Moderate

Passi

4

Tempo Necessario

30 - 45 minuti

Introduzione

This step-by-step guide will help you replace a damaged camera on a Zeki TBQG884B tablet.

A proper functioning camera is essential for capturing photos, scanning documents and engaging in video calls. If the camera is faulty or damaged, replacing it will help restore these functionalities.

  1. eOwIOvA4RkLX5ZWy
    eOwIOvA4RkLX5ZWy
    1jPhDnXkJrOsldih

    • Remove the two screws from the end of the device where the ports are located using a Phillips #1 screwdriver.

  2. 3QGn1QPTnASbL5Sg

    • Place the tablet down so that the screen is facing away from you.

    • Insert the tip of your opening tool into the small gap between the gray and white plastic covering. Pry it open and you should hear the clips opening up.

    • Gently work your way around the perimeter of the tablet's edge.

  3. E53yqeu2DG6g2MMx
    E53yqeu2DG6g2MMx
    X1mJSgUI1HlAkWPX

    • Remove the back cover

    • Remove any tape on the speaker and detach the speaker from the back plate.

    • The speaker is connected to the motherboard by two soldered wires. Don't break them when you remove the speaker.

  4. ibQtYfFiS1UusyFY
    ibQtYfFiS1UusyFY
    OKWRVTXgfJRm1fP1

    • Open the ZIF connector, the black lock part over the wire ribbon in the motherboard, and remove the wire ribbon that connects the motherboard and the camera.

    • The camera is located on the top left, above the motherboard.

    • The camera is usually covered with tape or material. Peel material/tape off with tweezers for safety.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Natalie Holm

Membro da: 16/09/15

137 Reputazione

0 commenti