iMac G5 20" Model A1076 Fan Duct Replacement

Scritto Da: Andrew Bookholt
  • Commenti: 2
iMac G5 20" Model A1076 Fan Duct Replacement

Difficoltà

Easy

Passi

4

Tempo Necessario

Nessuna stima

Introduzione

The fan duct directs air across the heat sink on the logic board.

  1. vWrrXC1PF4f4EOGg

    • Lay the iMac display-side down on a flat surface.

    • Loosen the three Phillips screws securing the rear panel to the iMac.

    • These screws are captive in the iMac. The center screw will stop turning after about 3.5 turns and the outer screws will stop turning after about 5.5 turns. Do not try to remove these screws from your iMac.

    Some models (with light sensor) have only the two outboard screws.

    Robert Huber -

  2. ZqkNk6XIHbtLZU1K
    ZqkNk6XIHbtLZU1K
    tQCIapnSNJOrtXIP

    • Lift the rear panel slightly near the bottom of the iMac.

    • Pull the rear panel toward yourself and remove it from the iMac.

  3. WyWshrR6reopCNyX

    • Remove the following two screws:

    • One 11 mm T10 Torx.

    • One 10.6 mm T8 Torx.

    Mine were just Philips screws? A1076 model...

    Albrt -

  4. ZGRHZDxZLC3OZHcT

    • Lift the fan duct out of the chassis.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Andrew Bookholt

585555 Reputazione

0 commenti