iPad 3 Wi-Fi Power & Volume Button Assembly Replacement

Scritto Da: Walter Galan
  • Commenti: 0
iPad 3 Wi-Fi Power & Volume Button Assembly Replacement

Difficoltà

Moderate

Passi

9

Tempo Necessario

Nessuna stima

Introduzione

Internal Prereq.

  1. bSSuCJl3oyuhJ4A5

    • Remove the following screws securing the power & volume button cable to the aluminum frame:

    • Two 5.5mm Phillips #0

    • One 2.6 mm Phillips #0

    • Two 2.6 mm Phillips #0

    • These screws are angled into the aluminum frame. Be sure to always hold the screwdriver in line with the screw.

  2. dbbOBZVaTXGcKO5w

    • Remove the piece of plastic covering the volume buttons.

  3. 51LfOKCtCXU6AeyY

    • Remove the single 2.6 mm Phillips #00 screw holding the volume button frame to the aluminum frame.

    • This screw is angled into the aluminum frame. Be sure to always hold the screwdriver in line with the screw.

  4. cOf2MtJXtNELIYEP
    cOf2MtJXtNELIYEP
    6VXFSWPfCjbYMpVE

    • Wedge the edge of a plastic opening tool underneath the sleep/wake sensor, being careful to not damage the fragile cable.

    • Move the plastic opening tool around the sensor, releasing the adhesive.

  5. bPg5DYPyXIkith3m
    bPg5DYPyXIkith3m
    tTurcDGWSHJTEmPU

    • Continue sliding the plastic opening tool underneath the power & volume cables, releasing the adhesive.

  6. osPEGx1JukkInyHu
    osPEGx1JukkInyHu
    yPA3kG1fBhvkOIdi

    • Using the tip of a spudger, release the adhesive underneath the volume button branch of the ribbon cable.

  7. G4rcWvPsSjDlKgmW
    G4rcWvPsSjDlKgmW
    MSlrVSoq4SJTaUHB

    • Continue sliding the tip of the spudger toward the top of the iPad, releasing the adhesive.

  8. THXtoVYqZIhfxoCT
    THXtoVYqZIhfxoCT
    vAUXPkAduby3RqQk
    5q2AP2m3nEHcSaJp

    • With the tip of the spudger still underneath the ribbon cable, gently lift the power button out of its socket in the aluminum frame.

  9. Px2vgBkyk6A34CoL
    Px2vgBkyk6A34CoL
    BYm3jRfaB3foeRDG

    • Holding the power & volume button cable with with both hands, carefully pull the volume buttons and lock switch from their sockets in the aluminum frame.

    • Lift and remove the power & volume button cable out of the rear aluminum case.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Walter Galan

693768 Reputazione

0 commenti