Disconnect Left-Over Logic Board Connectors

Scritto Da: Adam O'Camb
  • Commenti: 0
Disconnect Left-Over Logic Board Connectors

Difficoltà

Moderate

Passi

3

Tempo Necessario

Nessuna stima

Introduzione

Prerequisite-only guide to disconnect left-over logic board connectors during the upper case procedure.

  1. oNRVH41uTpIelDwD
    oNRVH41uTpIelDwD
    xkM22LWLgbli15DJ

    • Use a T3 Torx driver to remove the two 1.4 mm screws securing the trackpad connector bracket.

    • Remove the trackpad connector bracket.

  2. FDnbpjcCh1RpF1fI
    FDnbpjcCh1RpF1fI
    dKX52BOLsAUayLWG

    • Use the flat end of a spudger to pry the trackpad cable connector up and out of its socket.

  3. hSwIgKxxFZOjItAv
    hSwIgKxxFZOjItAv
    NsHhPS5ATbbFYULS
    ggROMyloGsQBjYdh

    • Use a spudger to lift up the small locking flap on the sound board cable's ZIF connector.

    • Slide the sound board cable out of the ZIF connector.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Adam O'Camb

Membro da: 11/04/15

195148 Reputazione

0 commenti