How to Upgrade the Expandable Storage in Your PlayStation 5 Slim

Scritto Da: Spencer Day

Difficoltà

Easy

Passi

Tempo Necessario

10 - 20 minuti

Introduzione

Follow this guide to install an M.2 SSD in the expandable storage slot in your PlayStation 5 Slim.

Increasing your PlayStation's storage with an upgraded SSD allows you to store more games, movies, music and other media on your device locally.

Before starting this repair:

Make sure your M.2 SSD is compatible with your PlayStation. M.2 SATA SSDs are not supported. Your SSD should have a heat-dissipation mechanism, such as a heatsink or thermal pad.
If the SSD you're installing has previously been used and still has data on it, back up the data before installing the SSD. The formatting process during setup will fully erase the drive.

The upper cover is secured with hooks along the back edge and clips along the front edge.
Firmly pull up the front edge of the cover to release the clips.
You'll hear distinct "pops" as the clips disengage.
Remove the cover.
To reinstall the cover, place the hooks into their cutouts along the rear edge and firmly press the front edge of the cover into place to re‑engage the two clips.

Use a Phillips screwdriver to remove the 17.1 mm‑long screw securing the expansion slot cover.

Use your fingers to lift the expansion slot cover near the notch by the screw hole and remove the cover.

Use a Phillips screwdriver to remove the 10.9 mm‑long SSD screw securing the spacer.

Multiple indents along the expansion slot allow for compatibility with any sized SSD. Each indent is labeled with its corresponding size.
Use tweezers or your fingers to move the spacer to its proper indent based on the size of your SSD.
Do not install the SSD without the spacer.

Make sure your SSD is compatible with your PlayStation and has a heat-dissipation mechanism such as a heatsink or thermal pad.
Insert the SSD into its M.2 socket at a slight downward angle.
Both the SSD and M.2 socket are keyed, which means the SSD only fits into the socket one way.
It's normal for the SSD to sit up at an angle before it's secured in place
With one hand, push the SSD down so its cutout is aligned on top of the spacer.
With your free hand, use your Phillips screwdriver to tighten the SSD screw.
Do not overtighten this screw, as doing so may damage the SSD.